Roof repairs in Sydney start with finding the exact spot where water gets in, whether your roof leaked after rain or after a storm.
The stain on your ceiling is only where the water finally showed up. Before it got there, it ran along battens, across insulation and down a wall cavity, sometimes a metre or more from the real opening. We trace it back, repair that opening, and tell you plainly if the roof has reached the point where patching stops making sense. Repairs are one part of our roofing services, which also cover replacement and gutters.
What causes a roof to leak?
Most leaks come from a small part that has failed, not from the whole roof. These are the usual culprits on Sydney homes:
- Cracked or slipped tiles. A single broken tile lets water onto the sarking and battens underneath. Wind, a fallen branch or someone walking on the roof can crack one.
- Lifted or rusted flashing. Flashing is the metal strip that seals the roof where it meets a wall, chimney, skylight or vent pipe. When it lifts or corrodes, rain runs behind it.
- Loose ridge capping. The caps along the top of a tile roof are bedded in mortar or fixed on a flexible seal. Mortar can crack, and either fixing can let go as the roof moves with heat and cold.
- Blocked valleys. A valley is the channel where two roof planes meet, and it carries the run-off from both planes. Leaves and grit make it overflow under the tiles.
- Rust at metal seams and fixings. On Colorbond and other metal roofs, water gets in at overlaps, around screws and where a sheet has rusted through.
- Overflowing gutters. Water that cannot leave the gutter backs up under the first row of tiles or sheets. The gutter side of the fix is gutters and downpipes work.
Each of these fails differently, which is why the repair has to match the cause. Clearing a blocked valley does nothing for a rusted sheet, and a new sheet will not cure a lifted flashing.
Storm damage: what to do before the roofer arrives
Storm damage looks dramatic, but the first jobs are simple. If your roof has been hit, do this:
1. Stay off the roof. Wet tiles and sheets are slippery, and a roof that is already damaged may not hold your weight. 2. Move belongings away from the wet area and put a bucket under any drip. 3. If a ceiling is bulging or sagging, it is holding water. Keep out of that room. 4. If water is near a light fitting or power point, leave the switch off and do not use it. 5. Take photos of any damage you can see from the ground, inside and out, with the date on them. 6. Ring 1300 164 206.
We make the roof watertight first. If the weather will not let us finish the job, we fit a temporary repair, then come back in dry conditions for the permanent one. A temporary repair is there to stop the water, not to be the final fix, and we tell you which one you have.
Ask about detailed reports if you need one for an insurance claim. We can give you notes on what we found and what we repaired.
Which tile roof problems get repaired?
Most local tile faults can be repaired.
- Broken or missing tiles are replaced, and the surrounding tiles are checked for cracks you cannot see from below.
- Ridge capping that has come loose is re-bedded and repointed, or refixed where the roof uses a flexible seal.
- Flashing is resealed or replaced where it has lifted, split or rusted.
- Valleys are cleared and the metal underneath is checked for holes.
- Slipped tiles are refitted and held down properly.
A tile that looks fine from the ground can still be cracked on the underside. That is why we climb up and look instead of quoting from a photo.
Which Colorbond and metal faults can we fix?
Metal roofs fail in different places from tile roofs, mostly at joins and fixings.
- Rusted sections are cut out and replaced, or treated and sealed where the steel underneath is still sound.
- Leaking seams and overlaps are resealed.
- Loose or corroded screws are replaced.
- A damaged sheet is swapped for a new one.
- Flashing around vents and skylights gets refitted or renewed.
Flat roofs are also part of our repair work, and a leak there follows the same rule: find the cause first.
Is it time for a new roof instead of another repair?
A repair is the right answer when one area has failed and the roof around it is sound. It stops being sensible when you are paying for the same job again every season.
Replacement deserves a conversation when:
- tiles crumble or flake when handled, not just crack
- rust has spread across many sheets, not one or two
- the same area leaks after more than one repair
- the roof sags between rafters
- battens or sarking are rotten, so new tiles would sit on a weak base
If we find any of these, we will say so and explain why. A patch that will not hold only delays the next leak. The lasting fix is then full roof replacement in tile or Colorbond.
How does a roof repair visit work?
1. You phone or fill in the form. Tell us what you can see: where the stain is, when it leaks and what the weather was doing. 2. We inspect. A roofer goes up on the roof and looks at the tiles or sheets, flashing, valleys, ridge capping and gutters, not only the spot above the stain. 3. We show you what we found. You get a plain explanation of the cause, and whether it is a repair or a bigger job. 4. You agree the price before work starts. The quote is agreed first, with no hidden costs. 5. We repair the cause. The repair is matched to your roof type and to what failed. 6. We check and tidy up. We look over the repair and clear away the offcuts and broken pieces.
If the leak is hard to pin down, we may suggest a dedicated leak detection visit before repairing anything, so the repair goes on the right spot.
We work under NSW contractor licence 273594C and we are insured. Our Lifetime Labour Guarantee means that if our workmanship causes a failure and the work is defective, we cover the labour. Parts are not covered.
What decides the price of a roof repair?
Every roof is different, so we price after we have seen it. These are the things that move the number:
- how many tiles, sheets or metres of flashing need work
- whether the roof is tile, Colorbond or another material
- the pitch of the roof and how hard it is to reach
- how many storeys the house has
- whether the damage has reached battens, insulation or the ceiling below
- whether a stopgap has to go on first
Repairing a leak is often cheaper than replacing a roof, but only when the fault is local. Repeated patches on a roof failing everywhere cost more than they save. We give you the choice with the facts in front of you.
Get your roof repair quote
If water is coming through your ceiling or a storm has left damage, call us on 1300 164 206 or send the quote form. We will look at the roof, talk you through it and settle the price before anyone picks up a tool.
If you will need roof work again in the years ahead, the AHS Cover Care membership is a single payment of $99, with 15% off roofing and $50 off your first service.
Request a Quote
"*" indicates required fields
Testimonials
Great Services, Happy Clients
Here at Aussie Home Services, our goal is simple: do the job properly, and leave you glad you called.
FAQ's
How much does it cost to fix a leaking roof?
The cost depends on what has failed and on access, so we do not publish a price. A few loose ridge caps and a rusted section of metal roof are very different jobs. We look, explain what is wrong and agree a figure with you.
Is it cheaper to repair or replace a roof?
A repair costs less when a single spot is faulty and the surrounding roof is sound. The balance tips when leaks keep returning in different spots, or when rust, rotten battens or crumbling tiles are spread across the roof. We inspect first, tell you which side of that line your roof is on, and give you the reasons.
What should I do first after storm damage to my roof?
Keep off the tiles and sheets, stay out of any room with a bulging ceiling, and leave anything the water has reached switched off. Take dated photos from the ground and inside, then call 1300 164 206. Our first job is stopping the water, and the permanent repair follows when conditions allow.
Do you repair roofs across Sydney?
Yes, our roof repairs cover homes across Sydney, on tile and Colorbond roofs. We are a mobile team, so we come to you. Phone 1300 164 206 with your suburb and we will arrange a time to inspect the roof and quote the repair.
What happens when your roofer arrives?
We climb up, find where water is getting in and explain the cause. You then get a price before anything starts. Once the repair is done we check it and clean up. If the cause is not obvious, we may suggest leak detection first, so we repair the right spot.
Is there a call-out fee, and what about after hours?
There is no call-out fee when the booking is for the following day or later. We take calls every day of the year. Evening and weekend rates differ, and the price is agreed before work starts, so you know what you are paying before we begin.
Need Experts For Your Plumbing Or Electrical Issues In Sydney?
Qualified, Licensed Professionals Delivering Reliable and High-Quality Results